86-18013983757 info@se-test.com

UL Rain Test Apparatus

Test Equipment:  UL Rain Spray Test Apparatus for Outdoor electrical enclosure waterproof test
Model No.： RT101B
Applicable Standards: UL1598 / CSA250, UL50E / CSA 94.2, UL 8750 / CSA 250.13, etc. and IEC/EN standard requirements.

Applications： For test laboratory, manufacturer or product designing use, to check the enclosure waterproof of Outdoor installed equipment, such as Street Lighting fixtures and Control panels etc, similar to IEC 60529 IP Code testing.

Specifications:   Detailed in dimensions/drawings of any of above standards.

  • Water pressure gauge: 0 to 20psi.
  • Water Spray nozzles comply with of any of above standard requirements.
  • The height of three spray heads is adjustable up and down.

 

Specification：

See dimensions/drawings of any of above standards

 

Keywords

Outdoor Luminaires
Outdoor LED Lighting
water entry protection for enclosure
waterproof for enclosure bottom
IP Code enclosure test
Outdoor Lighting fixture waterproof
UL 1598 CSA 250
IEC 60529 IP code test
water seal

UL 淋雨喷嘴（喷头）
UL美标喷淋
UL淋雨喷嘴(喷头)， UL喷洒头，UL美标喷淋,UL喷洒头试验装置

主要技术参数：

1.使用水源：保证水流压力为50～150kpa 内的清水；
2.试验用水流速率为≥10L/min；
3.水压表量程：0～0.25mpa(如图)；
4.喷水头的孔符合UL60507 图38.2 或UL1598 19.17.2中的要求；
5.红旗精密压力表：4 个。
6.试验时，每个UL喷头水压保持在34.5kPa左右

产品名称：UL美标淋雨喷嘴 (UL Spray Head 喷头)
应用标准:  UL 1598 / CSA 250；UL 153 / CSA 12；UL 50E / CSA 94.2；UL 48 / CSA 207；UL 8750 / CSA 250.13; UL 879，UL 82等等。
产品用途：用于防水试验机，模拟室外安装的仪器设备 (如室外电柜， 灯具类: 路灯，墙壁灯等）的淋雨测试。
备   注： 该淋雨喷头为进口产品，符合UL/CSA/IEC等国际标准要求.
  • Climate chamber,
  • UV Sunlight resistant test
  • UV Radiation light
  • Agingtest
  • Programmable Accelerated
  • Environmental testing, outdoor enclosure

 

Ageing Oven:

  • Accelerated thermal ageing procedures
  • Precision hot air circulation drying aging oven

 

UL1598-2004 UL Rain Spray Test Apparatus – from Shenzhen bond

Model:BND-UL

The UL water spray test device is based on the requirements in Figure 38.1 and Figure 38.2 of the UL60507-ENGL 1999 standard and the “Article 10 / Figure 11 clauses in the ANSI Z21.10.3-2004” and “ANSI Z21.58 standards” and “CSA4.3 -2004 “standards to meet UL1598, UL153, UL154B, UL1703, UL8750, UL1741, UL514B, UL1278, UL1571 and other standards.

1. Applicable to UL rain test and 45 ° water spray test of products.
2. This device consists of two parts: UL rain test device (3 UL nozzles above) and sprinkler test device (1 UL nozzle below).
3. The frame part of this device is made of molded aluminum material, which has a stable structure and is easy to clean.
4. The nozzle holder is movable and can be freely raised and lowered by a hand-cranked stainless steel wheel device.
5. This device adopts the original imported nozzle of UL laboratory, which fully complies with UL standards.
6. The base of the bracket adopts universal castors with brakes, which is convenient for movement and fixation. 7. Adopt the domestic brand “Hongqi” stainless steel pressure gauge to display the water spray flow (each nozzle has a corresponding pressure gauge).
8. The nozzle layout of the equipment is strictly designed according to the standard, as shown in the figure:

Specification

1

Equipment external dimensions Nozzle 

Approx. Length 1500 * width 800 mm

2

Adjustable range of equipment height

1000 ~ 2000mm

3

Nozzle number

4

4

The distance between the water spray junction and the ground

0-1000mm

5

Lower nozzle spray angle

45 ° (horizontal direction)

6

Water flow rate

≥10L / min

7

Total water pressure

50 ~ 150Kpa

8

Single nozzle pressure

34.5Kpa

9

Number of pressure gauges

5